Please read all the steps below before you fit your decals.

Tools and materials required for decal installation:

- Water dispenser bottle with spray head
- Washing up liquid or baby shampoo
- Squeegee for vinyl application

STEP 1
For ease of application place the wheel on the floor face up. Make sure the wheel face is clean prior to fitment. A detailing spray is ideal for this task. Any non-factory coatings present on the wheel prior to fitment may cause issues with the sticker adhesive.

STEP 2
Prior to fitment the sticker’s adhesive backing paper must be removed. We recommend you spray a fine mist (not a jet) of water mixed with a drop of washing up liquid or baby shampoo to the wheel face and to the newly exposed adhesive of the sticker.
The use of water and a small amount of soap helps reduce air bubbles forming and will allow you to adjust the decal without damaging it.

STEP 3
Position the decal so it is vertically aligned to the centre of the IW logo on the wheel face. To assist with fitment the circular decal will fit flush to the spoke tips on the inner edge of the wheel. Once in the correct position apply pressure with a squeegee to squeeze out any excess water.

STEP 4
Carefully peel back the backing paper in segments to reveal the decal. Please note the decal may lift off the damp surface so we advise that you use the squeegee to hold the decal in position whilst removing the backing paper. Work around the wheel in small segments. Once removed gently wipe off any water and allow the decal to dry.